Yamaha StagePas 1K Setup & Operation Guide

StagePas1K Bundle

 

 

Step 1. Carefully remove the speaker and extender sections from the rollerbag

 

Step 2. Find the power cable and microphone & cable in the side pocket

 

 Step 3. Unbuckle two latches on the bottom of both sides of the roller bag

 

Step 4. Lift off the top portion of the rollerbag

 

Step 5. Carefully insert the bottom section of the tower. Repeat for the second section. The speaker section goes on top. 

 

Step 6. Fully Assembled

 

Step 7. Plug in the power cable then plug into the wall

 

Step 8. Attach microphone to mic stand and click in microphone cable

 

Step 9. Plug other end of mic cable into Channel 1

 

Step 10. Make sure the white volume controls are turned off (set at 0)
(make sure the Mic/Line button is clicked out)

 

Step 11. Make sure the Red Master Volume is turned off (set at 0)

Step 12. Turn the power on (switch is by the power plug)

 

Step 13. Turn the Red Master Volume about 1/2 way up

 

Step 14. Have someone speak into the microphone and slowly turn up the white channel volume to the desired level

 

PRO TIP: Speak directly into the microphone for best results

 

Step 15: Press & hold Bluetooth button for approx 5 seconds. Pair to your device for audio streaming (and optional Yamaha StagePas App control)

 

PRO TIP: What is Ducker? If you are playing music through the system and this button is engaged, speaking into the microphone will automatically drop the music volume to give the microphone priority - so you don't have to adjust the volume controls 

 

PRO TIP: Very Important: Push this locking release tab before pulling out the microphone cable